Hem SAQ Forum SAQ Transmissions SAQ transmission24-12-2016

Detta ämne innehåller 1 svar, har 2 deltagare, och uppdaterades senast av  Frank 6 månader sedan.

  • Skapare
    Ämne
  • #5459 Svar
    Erik Tiddens
    PD1ET
    Deltagare

    Living in the quiet part of the Netherlands there is still a lot of QRM. We (PD1ET, PA0T and PA1NG) decided to create our own interference-free shack in the middel of nowhere. We parked our camerbus in the fields between Wildervank en Spijkerboor. Power was taken from two ‘stand-alone’ jelly batteries from some 20Ah.
    We used three set-up’s:
    A Kenwood R1000 with a VLF convertor (from Funk Amateur) and a MiniWhip active antenna;
    A Yaesu FRG7700 with NO convertor and it’s own MiniWhip;
    A laptop with the SAQ DSP software on it and a piece of wire.
    All three setups gave good reception of the tuning and the actual transmission of SAQ. Interference level was low and signals were som 20-30 dB over the noise floor.
    The MiniWhips were mounted on a fiberglass mast some 5 meters above ground.
    Next time we will bring in a seperate attenuator between the receiver and the antenna’s. It;s probably the only place to kill unwanted signals which might easaly arise. For instance: the regulator for the solar-panel on the camper-roof might cause interference… not that we noticed, but be aware! Fridges, ledlights… Round up the usual suspects!
    All in all a succefull attempt to receive SAQ -with lessons learned!

  • Författare
    Svar
  • #5462 Svar

    Frank

    Ufb,
    8.00Utc
    JN57IN
    5 7 9
    Racal 1772
    DL3MBJ
    73.

Svar till: SAQ transmission24-12-2016
Din information:





<a href="" title="" rel="" target=""> <blockquote cite=""> <code> <pre> <em> <strong> <del datetime=""> <ul> <ol start=""> <li> <img src="" border="" alt="" height="" width="">

Avbryt